Multifunction Table Lamp

Another log found near the road: The rotten shell was peeled and the whole log was cleaned. The metal rings were installed to prevent further cracks: The branches of the 3-arm lamp part was prepared with 2×4’s: The fans were placed on the fan-pole and cabling was completed:  ...

A Different Stationary

This was developed to provide all of your pens avaliable to you all the time. The pens were tied to some flexible cables and hanged on a log abover your work table. You will not loose any one of your pens after this product… 2018-03-17...

Chess Table with lights

The log was cleaner and the required grooves were prfepared: The led stripes were placed inside and the table was completed:   2018-03-05...

Table lamp with a zipper

One of the logs with a big crack was used in this project. The main difference was that a zipper was placed on the crack: 2018-03-15...

Open circuit

Another experimental product: An open radio and amplifier circuit: 2018-01-31  ...

Floor Lamp with Magnets

This was an experimental work. The idea was to install led’s into the magnets so that two opposing leds will float. 2018-01-02  ...

A Corner Table

The log was cleaned and varnished: The supports for the glass top was placed and the glass was installed on top: The color led stripes were installed in the inner part of the log and connected to the power supply: 2017-12-26...

Floor lamp with panel leds

4-part floor lamp. The wooden slices were drilled to allow the metal pipes as the legs. Also the circular holes for the panel leds were prepared underneath of each slice. The slices were glued to the legs and the power cable was brought to the bottom via one of...